Table of Contents
Advertisement
Connecting the
Live100 Boards
Together
To connect the two Live100 boards together, use the supplied ribbon
cable, and follow the directions below.
VGA Video
board
To connect the boards together, follow these steps:
1. Grasp the connector on one end of the ribbon cable so that you
can squeeze the tabs along the sides.
2. Line up the key on this connector with the interboard connector on
top of one of the Live100 boards.
The ribbon cable has 100-pin connectors. When you connect
the cable to the Live100 boards, be careful not to damage the
pins.
3. Slide the key into the interboard connector while squeezing the
tabs, keeping the top of the connector parallel with the top of the
board.
4. Click the tabs into the locks on the sides of the interboard
connector.
Connecting the Live100 Boards Together
Ribbon cable
Interboard connector
Caution
Audio Communications
board
3-7
Advertisement
Table of Contents
