Table of Contents
Advertisement
Installing the
Data-Dialer
Module/Network
Interface Board
Software
Installing the Data-Dialer Module/Network Interface Board Software
To install the software for the Data-Dialer Module/Network
Interface Board, perform the following procedures:
1. Install the Live50/Live100 application software, as instructed in
Chapter 4, Installing PictureTel Live Software.
Note: If you have already installed the Live50/Live100
application software, verify that your Live50/
Live100 hardware is working properly. For
instructions, refer toVerifying Your Installation in
Chapter 4.
Insert the DDM/Network Interface Board
Installation Software Disk 1 of 2 into drive A: or B:.
2. Fromthe Windows 3.1x Program Manager, Select File...Run. From
the Windows 95 Start Menu, select Run... Program.
3. Type A:SETUP or B:SETUP. Press Enter, and follow the on-screen
instructions to install your software.
4. When the software installation is complete, select PictureTel
Live50/Live100 Configure from the PictureTel Program Manager
group.
5. The Registration Confirmation window is displayed.
Click Continue.
C-27
Advertisement
Table of Contents
