Table of Contents
Advertisement
INSTALLING NETWORK INTERFACE BOARDS
Installing the
Switched-56
Network Interface
Board
C-6
The Switched-56 Network Interface board allows you to connect
your PictureTel
Live" videoconferencing system to a digital data
!
network using a Switched-56 interface.
These components are included with your Network Interface board:
Component
Switched-56 Network Interface board
Live50 CHI to MVIP cable (1)
Live100 MVIP cable (1)
Switched-56 chassis label (1)
Loopback test cables (2)
Switched-56 network cables
PictureTel Live50/Live100 Network
Interface Installation Guide
Your Switched-56 Network Interface board uses 01C0 (hexadecimal)
as its default I/O port address, which is set using a DIP switch. It
also uses IRQ 15 as its default IRQ setting, which is set using a
jumper. The next section explains how to change these settings if
necessary.
Before you install the Network Interface board, you should
check and configure the environment on your ISA-bus or
EISA-bus PC. Refer to Appendix A, Checking Your PC Settings
for instructions.
Quantity
1
1
1
1
2
2
1
Caution
Part
Number
180-0293-01
510-0167-01
800-0610-02
Advertisement
Table of Contents
