Table of Contents
Advertisement
Installing the
VGA Video Board
To install the VGA Video board, follow these steps:
1. Remove the VGA Video board from its plastic antistatic package.
The VGA Video board can be damaged by static discharge.
To equalize static charge, ground yourself by touching the
metal back panel of your PC.
You can identify the VGA Video board by the 15-pin VGA
connector on the back plate.
Interboard connector
2. Insert the board into the selected expansion slot.
Make sure the board is securely seated in its slot.
3. Secure the board by replacing the screw that holds the back plate.
Note: The VGA drivers for your video board need to be
installed after you have finished with the Live100
hardware installation. Refer to Chapter 4, Installing
PictureTel Live Software for installation instructions.
Installing the VGA Video Board
Caution
Insert into the
PC's expansion slot
Back plate
VGA
connector
3-5
Advertisement
Table of Contents
