Table of Contents
Advertisement
Installing the Data-Dialer Module/Network Interface Board Software
8. The DDM Base I/O Address and DDM IRQ fields appear on the
Hardware Settings window.
This window illustrates the default DDM base I/O address
setting. If your DDM base I/O address setting differs from the
default, the correct setting is detected and displayed.
If no changes are required, click Continue.
9. The Node Name Selection window is displayed.
If no changes are required, click Continue.
10. The Modify CONFIG.SYS file window is displayed.
If no changes are required, click No Change.
11. The Installation Complete window in displayed.
Click OK to reboot and restart your system.
12. Start the Live50/Live100 application, and select Tools >
Preferences.
C-29
Advertisement
Table of Contents
