Table of Contents
Advertisement
INSTALLING PICTURETEL LIVE SOFTWARE
Windows 3.1x Non-PictureTel VGA Driver Installation
Windows 95 Matrox Driver Installation
4-8
If you are installing a Live50 system with a Matrox! or Compaq!
QVision VGA board for a PCI bus and you are running Windows
3.1x, then you need to follow the installation instructions provided
specifically for that VGA video board.
1. Run the Setup program provided by the video board manufacturer.
2. After you have completed the installation, remove the VGA
installation disk from the diskette drive.
3. Open a Windows application to verify that the VGA board is
working properly.
If your selected setting causes your video display to appear
distorted, you need to run the setup program again and try a lower
resolution. This happens when the video display chip on your VGA
board is incompatible with your selected setting.
After you verify that the VGA board is working properly, follow the
instructions in the next section for using the Setup Wizard
If you are installing a Live50 system with a Matrox! VGA board for
a PCI bus and you are running Windows 95, then you need to follow
this installation procedure. This procedure consists of three main
steps:
1. Installing the Microsoft MGA Driver 1.0 (available as part of
Windows 95)
2. Installing the MGA PowerDesk upgrade (disk supplied with
PictureTel Live50, Version 1.6)
3. Adjusting the "Desktop Area" and "Display Area."
Step 1: Installing the Microsoft MGA Driver
You may have installed a new Matrox VGA board as part of the
Live50 hardware installation, or your Matrox board may have been
installed from a previous version of Live50 (formerly PCS 50). In
either case when Windows 95 is first started with the Matrox board
installed, Windows 95 acknowledges the Matrox VGA board and
automatically installs the Microsoft MGA 1.0 driver.
Advertisement
Table of Contents
