PictureTel LIVE50 Installation Manual page 84

INSTALLING PICTURETEL LIVE SOFTWARE
4-16
If you are connected to a public network in Germany and you have
installed either the Live50 or Live100 system, you have the
following choices:
Euro-ISDN
!
ITR6
!
Note: If you are connected to a private network, or if your
country appears on the list more than once, or if your
country does not appear in the list displayed by the
Setup program, and is not in the list of countries that use
Europe: Euro-ISDN, you must contact your network
service provider to determine which protocol you
should select during installation.
7. Enter the Service Provider IDs (SPIDs) for the B channels (in the
United States and Canada only)
On fully-initializing switches (this includes 5ESS CUSTOM
Multipoint, DMS CUSTOM Multipoint, and National ISDN (NI-
1)) in the United States and Canada, you must enter the SPIDs
assigned to you by your network provider. Unless these items
are entered correctly, you will not be able to make or receive
calls.
8. If you are connecting your Live system to an ISDN network outside
of North America, you may need to specify the "Number Type" and
"Number Plan" used by that network.
This is done when you specify the ISDN protocol. The pull-
down menus which allow you to specify the Number Type and
Number Plan appear only if needed.
If you do not know the proper settings, you can attempt to
proceed with the installation using the default values. If you
then have difficulty originating or receiving calls, contact your
service provider to determine the proper Number Type and
Number Plan, and run the PictureTel Live Configuration
program to configure your system accordingly.
9. You need to specify the Multiple Subscriber Numbers (MSNs) for
those switches outside the United States and Canada that permit
multiple terminals, each with a unique set of ISDN phone numbers,
to be connected to a single line. For such switches inside the
United States and Canada, you need to specify the equivalent