Table of Contents
Advertisement
INSTALLING PICTURETEL LIVE100 HARDWARE
Opening Your PC
3-4
6. If there is a conflict, change the corresponding switch settings in
your Live100 boards, as described in Appendix B.
To open your PC and prepare it for the Live100 boards, follow these
steps:
Note: For BABT (British Approvals Board for
Telecommunications - United Kingdom) and AUSTEL
(Australia) requirements for installing the Live100
board, refer to Appendix H.
1. Power off your PC.
Leave your PC connected to the power source to provide a
ground connection.
2. Disconnect your monitor cable, and other cables if necessary,
from the PC chassis.
3. Remove the chassis cover.
Refer to your PC documentation for instructions.
4. Remove your VGA board if it is a separate board, or disable VGA
on the motherboard.
Refer to your PC documentation for instructions on how to
disable VGA on the motherboard.
5. Locate two adjacent full-size expansion slots.
One of these can be the expansion slot from which you removed
your VGA board.
Note: If you are installing additional Live100 network
interface boards, locate slots for them as well. The
additional boards must not be more than one slot
away from the Live100 Audio Communications
board.
6. Remove the back plates of your selected expansion slots and save
the screws.
Advertisement
Table of Contents
