Table of Contents
Advertisement
3
3A
7
Mounting and Positioning the FlipCam
The cables for the speakerphone unit and the FlipCam are
similar, but they are not interchangeable. The end plugs on
the FlipCam cable are labeled
Speakerphone cable are labeled
wrong cable, you might damage the Live100 components.
Be careful when you connect or disconnect the cable. When
connecting it, be sure the flat side of the plug lines up with
the flat side of the socket, as shown by the socket label.
When disconnecting it, be sure to release the collar lock by
pulling on the plug's collar, not on the cable.
3. Plug the end of the cable without the ferrite bead into the socket at
the back of the camera near the hinge.
Both the plug and the socket are labeled
securely into the socket.
4. Press the cable into the guide on the camera base.
5. Be sure your PC is turned off.
6. Plug the end of the cable with the ferrite bead into the socket
nearest the VGA connector on the VGA Video board.
Both the plug and the socket are labeled
farthest from the VGA connector is also labeled
socket is for a second camera.)
Push the plug securely into the socket.
The FlipCam camera is designed with flexibility in mind. You can
mount it in several ways, and you can quickly switch from one
mounting option to another.
Connecting the FlipCam Camera
Caution
, and the plugs on the
8A
. If you connect the
7
. Push the plug
8A
. (The socket
8A
; that
8A
3-11
Advertisement
Table of Contents
