Installing Network Interface Boards - PictureTel LIVE50 Installation Manual

INSTALLING NETWORK INTERFACE BOARDS

C-2
3. Install the PictureTel Live application software using Chapter 4,
Installing PictureTel Live Software , for instructions.
Note: On the Network Interface Settings window, be sure
to select ISDN BRI only (and no additional
networks) to test your Live50/Live100 installation.
If do not have ISDN service, you should still perform
this step, selecting "AT&T 5ESS custom point-to-
point" as the ISDN protocol.
4. When the installation is complete, select Tools > Diagnostics >
Loopback to test the audio and video and verify the Live50/Live100
installation integrity.
5. Install the DDM/Network Interface board software as described
later in this document.
6. When the installation is complete, select Tools > Diagnostics >
Loopback to test the integrity of your DDM/Network Interface
board installation.