Table of Contents
Advertisement
CHANGING SETTINGS ON THE LIVE100 BOARDS
B-2
Figure B-1 shows the VGA Video board, which you can identify
by the 15-pin VGA connector on the back plate.
Figure B-1: VGA Video Board
2. Place the board on a level surface so that its component side faces
up and the back plate (with the connectors) is to your right.
3. If the default I/O port address setting of 27CA–27CE conflicts with
the I/O port address of another device in your PC, change the
setting for this board to 029A–029E by doing the following:
a. Refer to Figure B-1 and locate switch SW1 on the board
b. Use a ballpoint pen to slide the DIP switch labeled ADR2 on
SW1 to the right. This changes the I/O port address for this
board from 27CA–27CE to 029A–029E.
Do not use a pencil. The graphite can damage the switch.
SW1
ADR2
IRQ9
NOWS
ON
RSVD
OFF
Caution
Back plate
VGA
connector
.
Advertisement
Table of Contents
