PictureTel LIVE50 Installation Manual page 124

INSTALLING NETWORK INTERFACE BOARDS
C-14
To connect the two boards using the MVIP cable, follow these steps:
1. Grasp the connector on one end of the ribbon cable.
2. Line up the key on this connector with the slot on the expansion
connector attached to the front of the Live100 Audio
Communications board.
3. Slide the key into the expansion connector slot.
4. Repeat these steps to connect the other end of the ribbon cable to
the Network Interface board.
Connecting the Live50 CHI to MVIP Cable
For the Live50 product, connect the Switched-56 Network Interface
board to the Live50 board by using the supplied CHI to MVIP cable
with a 40-pin connector on one end and an 8-pin connector on the
opposite end.
Use care when connecting the CHI to MVIP cable to the
board so as not to damage the pins.
To connect the two boards using the CHI to MVIP cable, follow these
steps:
1. Grasp the 40-pin connector on one end of the cable.
2. Line up the key on this connector with the slot on the expansion
connector attached to the Network Interface board.
3. Slide the key into the expansion connector slot.
4. Connect the 8-pin connector to the Live50 board.
Note: Be sure to position the 8-pin connector so that the
white wire is closest to the back plate on the
Network Interface board.
Now you need to install the Live50 or Live100 application software,
as instructed in Chapter 4, Installing PictureTel Live Software.
Caution