Network Interface - PictureTel LIVE50 Installation Manual

Overview
This appendix contains installation instructions for the available
Network Interfaces for the Live50 and Live100 videoconferencing
systems. It also includes information on cable connections to the
Inverse Multiplexer (IMUX) devices, which provide a variety of
network solutions for videoconferencing applications.
The installation procedures differ slightly, depending on whether
you are installing the Switched-56 or the V.35/RS-449 Data-Dialer
Module/Network Interface board. The procedures for each type of
installation are summarized below:
To install the Switched-56 Network Interface board:
1. Install the Live50/Live100 hardware using Chapter 2, Installing
PictureTel Live50 Hardware or Chapter 3, Installing PictureTel
Live100 Hardware for instructions.
2. Install the Switched-56 Network Interface board.
3. Install the PictureTel Live application software using Chapter 4,
Installing PictureTel Live Software , for instructions.
To install the V.35/RS-449 Data-Dialer Module (DDM)/Network
Interface board:
1. Install the Live50/Live100 hardware using Chapter 2, Installing
PictureTel Live50 Hardware or Chapter 3, Installing PictureTel
Live100 Hardware for instructions.
2. Install the DDM/Network Interface board.

Network Interface

C
Installing
Boards
C-1