Table of Contents
Advertisement
INSTALLING NETWORK INTERFACE BOARDS
Unpacking the DDM/Network Interface Board
C-16
DDM RS-449 Kit
Component
DDM/Network Interface board
Live50 CHI to MVIP cable
Live100 MVIP cable
RS-449/RS-366 4-leg cable
DDM/Network Interface board
installation diskettes
PictureTel Live50/Live100 Network
Interface Installation Guide
The V.35/RS-449 Network Interface boards use 3CC0 (hexadecimal)
as the default I/O port address, which is set using a DIP switch. For
more information, refer to Changing the I/O Port Address on the DDM/
Network Interface Board (below).
Before you install the Network Interface board, you should
check and configure the environment on your ISA-bus or
EISA-bus PC. Refer to Appendix A, Checking Your PC Settings
for instructions on these procedures.
To unpack the DDM/Network Interface board, remove the board
from its protective box and then from the plastic antistatic package.
Quantity
1
1
1
1
2
1
Caution
Part
Number
180-0293-01
510-0167-01
180-0312-01
800-0610-02
Advertisement
Table of Contents
