Table of Contents
Advertisement
CHANGING SETTINGS ON THE LIVE100 BOARDS
B-4
2. Place the board on a level surface so that its component side faces
up and the back plate (with the connectors) is to your right.
3. If the default IRQ setting (IRQ 11) conflicts with the IRQ of another
device in your PC, change the IRQ setting for this board by doing
the following:
a. Refer to Figure B-2 and locate switch SW962 on the board
This switch has 10 sliding DIP switches. A DIP switch in the
up position is ON and in the down position is OFF.
b. Use a ballpoint pen to slide the DIP switch labeled 7, which
is IRQ 11, down to the OFF position.
Do not use a pencil. The graphite can damage the switch.
c. Make sure all switches are down in the OFF position before
proceeding to the next step.
d. Slide the DIP switch for your selected IRQ setting up to the
ON position.
Note: Only one DIP switch can be in the ON position.
You'll need to specify this IRQ setting during software
installation, as explained in Chapter 4.
Caution
.
Advertisement
Table of Contents
