Sending By Ip-Fax - Ricoh Aficio MP 2500SPF Facsimile Reference Manual

Transmission
B
Enter the fax number using the number keys.
1
C
Press [Tone].
D
Enter the number you want to tone dial using the number keys.
E
Press the {Start} key.
The transmission starts.
If you want to cancel a transmission, press the {Clear Modes} key, and then re-
move the originals.
After transmission, the standby display appears.
Note
❒ Certain services may be unavailable even when using the Tone function.
❒ A tone is shown as a "T" on the display and the next numbers are dialed using tonal signals.

Sending by IP-Fax

This section explains how to specify a destination using IP-Fax transmission.
When using IP-Fax transmission, specify the IP-Fax destination (IPv4 address,
host name, or alias telephone number) in place of the fax number.
Important
❒ To use IP-Fax functions, the optional printer/scanner unit must be installed.
❒ To send an IP-Fax document, in the Fax Features menu, configure the IP-Fax Settings as
follows. For details about IP-Fax Settings, see "Fax Features", General Settings Guide.
• If you are using a gatekeeper server, set [Enable H.323] to [On] and configure
the gatekeeper settings under [H.323 Settings].
• If you are using a SIP server, set [Enable SIP] to [On] and configure the SIP
server settings under [SIP Settings].
48