Lichtmodul; Programming Devices; Handheld Programming Device - Otto Bock Skippi Plus Service Manual

Hide thumbs Also See for Skippi Plus:

Table of Contents

8.4 Light module

The light module is mounted on the wheelchair with a retaining plate, a counter support and 4

screws.

Connections

Fig. 60

1 BUS connection

2 BUS connection

3 Light connection

The enAble50 control unit is programmable, i.e. the settings for the various programmable pa-

rameters can be set using a programming device. Two programming devices are available: a

handheld programming device and a PC programming station (PCPS). The PCPS has additional

functions not offered by the handheld programming device. On the other hand, the handheld

programming device is more portable. The PCPS is usually used to establish the initial param-

eter settings, while the handheld programming device is used for changes during practical use.

The 1313 handheld programming device is used to configure the connected enAble 50 control

system. With the programming device, you can adjust and save parameter settings, restore

previous settings, perform diagnostics and troubleshooting, and update the system's software.

Fig. 61

Handheld programming device

Skippi Plus

enAble50 wheelchair control – installation and programming

Ottobock | 55

Table of Contents