Programming Safety Instructions; Safety Instructions Regarding Maintenance And Repairs; Further Information; Nameplate - Otto Bock C1000 SF Instructions For Use Manual

CAUTION
Improper lifting
Crushing, pinching, blows due to failure to observe safety instructions
► Some parts of the power wheelchair, such as the batteries, frame, seat, and motors, are very heavy. Ensure
ergonomically correct lifting of these parts. Use sufficiently large hoisting devices or perform this work with a
helper.
► If it is necessary to work underneath raised parts or equipment, make sure these are secured by suitable
means so that they cannot come loose, shift, or fall down.
► When using lifting platforms, ensure that the power wheelchair is centred on the platform and that no parts
protrude into the danger zone.
CAUTION
Improper assembly after making adjustments
Tipping over, falling of the user due to incorrect assembly and adjustment
► Verify that the anti-tipper has been installed and adjusted properly.

3.4 Programming safety instructions

WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming the control device may only be performed by qualified personnel. The manufacturer of the
product and the control device manufacturer are not liable in case of damage caused by programming which
was not performed properly and/or which was not adjusted properly according to the user's abilities.
► Note that modified parameter settings in the configuration can lead to changes in driving characteristics. In
particular, changes to the speed, acceleration, braking or joystick settings can lead to unexpected and there­
fore uncontrollable driving characteristics and cause an accident.
► After configuration/programming is complete, the user must test the driving characteristics of the product
under the supervision of the qualified personnel.

3.5 Safety instructions regarding maintenance and repairs

CAUTION
Damage to the product, unexpected noise or odours
Health problems for the user
► Report damage to the product that may cause health problems for the user to Ottobock. This includes uncon­
trolled movements of the product as well as sounds that are unexpected or previously not noted or odours that
deviate significantly from the state of the product at the time of delivery.

3.6 Further information

INFORMATION
The serial number required for enquiries and orders can be found on the nameplate. For explanations of the
nameplate, see the section "Nameplate" (see Page 7).

3.7 Nameplate

The nameplates are found on the side of the frame under the seat.
C1000 SF
Safety
7