Programming Devices; Handheld Programming Device - Otto Bock Xeno Service Manual

Otto bock healthcare xeno power wheelchair

Hide thumbs Also See for Xeno:

Table of Contents

8.4 Programming Devices

The enAble50 control unit is programmable, this means that the settings for the various pro-

grammable parameters can be set using a programming device. Two programming devices are

available: a handheld programming device and a PC programming station (PCPS). The PCPS

has additional functions not offered by the handheld programming device. On the other hand,

the handheld programming device is more portable. The PCPS is usually used to establish the

initial parameter settings, while the handheld programming device is used to make adjustments

in the field.

The handheld programming device (493U36=SK180) is designed for programming, inspection

and debugging of the wheelchair modular control system (MCS).

Figure 94 Handheld Programming Device

Control and display elements:

1. LCD: Graphic display (128 x 64 pixels) to display functions and parameters.

2. Cross navigation key: A control element to navigate the cursor in the menu tree. Press the

up / down arrow to move the cursor vertically in the menu tree. Press the right hand arrow at

the branch points to open the corresponding sub-functions and press the left hand arrow to

close these sub-functions again.

3. Toggle switch: This control element is used to increase or decrease the selected parameter

values.

4. Programmable bookmarks: 3 user-defined bookmarks. This function enables you to jump

quickly among various points in the menu tree. To set a bookmark, select an item and press

the button for a long moment (at least 3 seconds). Then the cursor will jump to the predefined

position by pressing the button quickly.

Table of Contents