Removing The Crankshaft; Working On Individual Parts; Work On The Right Section Of The Engine Case - Husqvarna FE 250 2016 Repair Manual

18.3.33

Removing the crankshaft

18.4 Working on individual �arts
18.4.1

Work on the right section of the engine case

Take out crankshaft
Take off the right section of the engine case.
Remove all dowels.
Remove shaft seal ring
Remove nozzle
Remove oil nozzle
Remove screw
Remove oil nozzle for piston cooling.
Remove screws@). Remove the bearing retainers.
Remove any sealing mass remnants and clean the engine
case section thoroughly.
Warm the engine case section in an oven.
Guideline
11
so c
(302 °F)
0
Knock the engine case section against a level wooden plate.
This will cause the bearings to drop out of the bearing seats.
Info
Any bearings that remain in the engine case section
must be removed using a suitable tool.
Blow out oil nozzle
is clear.
Guideline
Oil nozzle for
balancer shaft
lubrication
Insert the new cold bearings in the bearing seats of the
heated section of the engine case; if necessary, use a
suitable press drift to push them all the way in and make
308660-10
them flush.
0-
O
of the crankshaft.
8.
8
for conrod bearing lubrication.
8.
(D
with compressed air and check that it
M4 2 Nm (1 .5 lbf ft)
18 ENGINE
®
Loctite 243
™
177