Starter Relay Removal and Installation
Removal
1) Turn the ignition switch OFF.
2) Remove the seat. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-6)".
3) Disconnect the battery (–) lead wire from the battery.
4) Disconnect the starter relay coupler (1) and remove
the starter relay cover (2).
2
5) Disconnect the starter motor lead wire (3) and
battery (+) lead wire (4).
6) Remove the starter relay (5).
3
Installation
Install the starter relay in the reverse order of removal.
B718H11906005
1
I718H1190039-01
4
5
I718H1190019-01
Starter Relay Inspection
Inspect the starter relay in the following procedures:
1) Remove the starter relay. Refer to "Starter Relay
Removal and Installation (Page 1I-7)".
2) Apply 12 V to "A" and "B" terminals and check for
continuity between the positive and negative
terminals using the multi-circuit tester. If the starter
relay clicks and continuity is found, the relay is ok.
CAUTION
!
Do not apply battery voltage to the starter
relay for five seconds and more, since the
relay coil may overheat and get damaged.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test (
"A"
To starter motor
Starting System:
B718H11906006
)
"B"
(A)
I649G1190021-04
-
+ To battery
"A"
"B"
I649G1190022-02
1I-7