Subaru 2009 IMPREZA Service Manual page 3142

Rear Gate Opener Button
SECURITY AND LOCKS
11.Rear Gate Opener Button
A: REMOVAL
1) Remove the rear gate trim. <Ref. to EI-66, RE-
MOVAL, Rear Gate Trim.>
2) Remove the rear gate garnish. <Ref. to EI-69,
REMOVAL, Rear Gate Garnish.>
3) Disconnect the rear gate opener button harness
connector.
4) Hold down the rear gate opener button hook,
and remove the rear gate opener button.
SL-00742
B: INSTALLATION
CAUTION:
Make sure that the harness grommet is secure-
ly installed.
If not properly installed, this may cause water
immersion.
Install in the reverse order of removal.
C: INSPECTION
1) Disconnect the rear gate opener button harness
connector.
2) Inspect the continuity between the rear gate
opener button connector terminals.
Switch Terminals Standard
Open Less than 1
No. 1 and No. 2
Close 1 M or more
If defective, replace the rear gate opener button.
SL-38