Subaru 2009 IMPREZA Service Manual page 1099

2. REAR SIDE BELT
CAUTION:
• Do not re-use the rear side belt.
• Be careful not to let oil, grease or coolant contact a new rear side belt.
• Be careful not to rub the belt end surface with bare hands; exposed core may cause injury.
• To install the rear side belt, always use the provided tools (belt stopper, belt guide, belt guide hold-
er, and bolt).
(B)
(A) Rear side belt
(B) Belt stopper
1) Wipe off any dust, oil and water on the groove of
each pulley with cloth.
2) Wipe off any oil, water, dirt, and rust on the front
of the crank pulley with cloth.
3) Slowly turn the crank pulley clockwise so that the
service hole of the crank pulley comes around the
top.
CAUTION:
Do not turn the crank pulley counterclockwise.
V-belt
(C)
(C) Belt guide
(D) Belt guide holder
4) Hook a new rear side belt on the A/C compres-
sor pulley.
5) As shown in the figure, insert the claw of the belt
stopper (A) to the lower hole (B) of the compressor
bracket, then attach with bolt (C).
ME-03500
ME(H4DOTC)-41
(A)
(D)
(E) Bolt
(A)
(C)
(B)
MECHANICAL
(E)
ME-03457
ME-03501
ME-03502