Subaru 2009 IMPREZA Service Manual page 1145

22) Install the water pipe assembly.
NOTE:
Use new O-rings.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
23) Install the water tank pipe assembly.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
24) Install the baffle plate.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
25) Install the oil strainer.
NOTE:
Use new O-rings.
Tightening torque:
10 N·m (1.0 kgf-m, 7.4 ft-lb)
26) Tighten the oil strainer stay together with the
baffle plate.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
27) Apply liquid gasket to the mating surfaces of oil
pan, and install the oil pan.
NOTE:
Install within 5 min. after applying liquid gasket.
Liquid gasket:
THREE BOND 1217G (Part No. K0877Y0100)
or equivalent
Tightening torque:
5 N·m (0.5 kgf-m, 3.7 ft-lb)
(A) Gasket
Cylinder Block
28) Apply liquid gasket to the mating surface of oil
separator cover and the threaded portion of bolt (A)
shown in the figure (when reusing the bolt), and
then install the oil separator cover.
NOTE:
• Install within 5 min. after applying liquid gasket.
• Use new oil separator cover.
Liquid gasket:
Tightening torque:
ME-00300
29) Use the ST to lock the crankshaft, and install
the drive plate. (AT model)
ST 498497100
Tightening torque:
30) Install the flywheel. (MT model) <Ref. to CL-13,
INSTALLATION, Flywheel.>
(A)
LU-02353
ME(H4DOTC)-87
Mating surface
THREE BOND 1217G (Part No.
K0877Y0100) or equivalent
Bolt thread (A) (when reusing the bolt)
THREE BOND 1324 (Part No. 004403042) or
equivalent
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
CRANKSHAFT STOPPER
72 N·m (7.3 kgf-m, 53.1 ft-lb)
MECHANICAL
(A)
ME-03333
ST
ME-00136