Subaru 2009 IMPREZA Service Manual page 1207

9. Radiator Sub Fan and Fan
Motor
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift up the vehicle.
4) Remove the under cover.
5) Disconnect the sub fan motor connector (B).
(B)
6) Remove the heat shield cover from radiator. (AT
model)
7) Lower the vehicle.
8) Remove the air
IN(H4DOTC)-11, REMOVAL, Air Intake Duct.>
Radiator Sub Fan and Fan Motor
IN-00203
CO-02367
CO-02355
intake duct. <Ref.
CO(H4DOTC)-27
9) Remove the bolts which secure the radiator sub
fan motor assembly and the over flow pipe.
10) Raise the radiator sub fan motor assembly
slightly, remove the pin at the lower part of the ra-
diator sub fan motor assembly from the radiator
hole, and remove the radiator sub fan motor as-
sembly from the lower side of the vehicle.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
Check if the radiator hose and the over flow
hose are properly connected.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
Tightening torque:
3 N·m (0.3 kgf-m, 2.2 ft-lb)
to
COOLING
CO-02512
CO-02512
CO-02355