Subaru 2009 IMPREZA Service Manual page 1093

Hide thumbs Also See for 2009 IMPREZA:

5) Remove the lifting device and wire ropes.

6) Remove the garage jack.

7) Install the pitching stopper.

Tightening torque:

T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)

T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)

8) Remove the ST from torque converter clutch

case. (AT model)

Be careful not to drop the ST into the torque con-

verter clutch case when removing the ST.

ST 498277200

9) Install the starter. <Ref. to SC(H4SO)-7, IN-

STALLATION, Starter.>

Engine Assembly

ME(H4DOTC)-35

10) Install the torque converter clutch to drive plate.

(1) Insert the wrench into the crank pulley bolt

and rotate the crank pulley to install the bolts

which hold torque converter clutch to drive

Be careful not to drop bolts into the torque convert-

er clutch case.

Tightening torque:

25 N·m (2.5 kgf-m, 18.4 ft-lb)

(2) Fit the plug to service hole.

11) Install the power steering pump.

(1) Install the power steering pump onto the en-

Tightening torque:

Refer to "COMPONENT" of "Power Steering"

for the tightening torque. <Ref. to PS-3, COM-

PONENT, General Description.>

(2) Connect the power steering pump switch