Subaru 2009 IMPREZA Service Manual page 1094

MECHANICAL
(3) Install and adjust the front side belt. <Ref. to
ME(H4DOTC)-40, FRONT SIDE BELT, IN-
STALLATION, V-belt.>
12) Lift up the vehicle.
13) Install the bolts and nuts which hold lower side
of the transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
• AT MODEL
• MT MODEL
14) Install the nuts which hold the engine mounting
to the crossmember.
NOTE:
Make sure that the engine mounting nuts (A) and
locator (B) are securely installed.
Tightening torque:
85 N·m (8.7 kgf-m, 62.7 ft-lb)
(B) (A) (A) (B)
15) Install the joint pipe and front exhaust pipe.
<Ref. to EX(H4DOTC)-7, INSTALLATION, Front
Exhaust Pipe.> <Ref. to EX(H4DOTC)-12, IN-
STALLATION, Joint Pipe.>
Engine Assembly
16) Install the turbocharger. <Ref. to IN(H4DOTC)-
16, INSTALLATION, Turbocharger.>
17) Install the center exhaust pipe. <Ref. to
EX(H4DOTC)-10, INSTALLATION, Center Ex-
haust Pipe.>
18) Connect the ground cable.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
AT-00108
19) Lower the vehicle.
20) Connect the following hoses.
(1) Fuel delivery hose, fuel return hose and
evaporation hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
21) Connect the following connectors and termi-
nals.
(1) Generator connector and terminal
Tightening torque:
15 N·m (1.5 kgf-m, 11.1 ft-lb)
(2) A/C compressor connector
MT-00077
(3) Secondary air pump connector
22) Install the engine harness connector to engine
harness bracket, then connect the bulkhead har-
ness connector to the engine harness connector.
23) Install the intercooler. <Ref. to IN(H4DOTC)-
13, INSTALLATION, Intercooler.>
24) Install the A/C pressure hoses to A/C compres-
sor. <Ref. to AC-38, INSTALLATION, Hose and
ME-03704
Pipe.>
25) Install the radiator. <Ref. to CO(H4DOTC)-21,
INSTALLATION, Radiator.>
ME(H4DOTC)-36
ME-03702
ME-03625