Subaru 2009 IMPREZA Service Manual page 1088

MECHANICAL
9. Engine Assembly
A: REMOVAL
1) Set the vehicle on a lift.
2) Change the bolt installation position from (A) to
(B), then open the front hood completely.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
(A)
(B)
3) Remove the V-belt covers.
4) Collect the refrigerant from A/C system. <Ref. to
AC-21, Refrigerant Recovery Procedure.>
5) Release the fuel
FU(H4DOTC)-60, RELEASING OF FUEL PRES-
SURE, PROCEDURE, Fuel.>
6) Remove the battery. <Ref. to SC(H4SO)-22,
REMOVAL, Battery.>
7) Open the fuel filler lid and remove the fuel filler
cap.
8) Remove the air intake duct and air cleaner case.
<Ref. to IN(H4DOTC)-11, REMOVAL, Air Intake
Duct.> <Ref. to IN(H4DOTC)-9, REMOVAL, Air
Cleaner Case.>
9) Remove the intercooler. <Ref. to IN(H4DOTC)-
13, REMOVAL, Intercooler.>
10) Remove the radiator. <Ref. to CO(H4DOTC)-
20, REMOVAL, Radiator.>
11) Remove the coolant filler tank. <Ref. to
CO(H4DOTC)-30, REMOVAL,
Tank.>
12) Disconnect the A/C pressure hoses from A/C
compressor. <Ref. to AC-38, REMOVAL, Hose and
Pipe.>
Engine Assembly
(A)
(B)
ME-03387
ME-03386
pressure. <Ref. to
Coolant Filler
ME(H4DOTC)-30
13) Disconnect the bulkhead harness connectors
from the engine harness connectors.
14) Remove the engine harness connector from
the engine harness bracket.
15) Disconnect the following connectors and termi-
nals.
(1) Generator connector and terminal
(2) A/C compressor connector
ME-03625
ME-03996
ME-03388
ME-03389