Subaru 2009 IMPREZA Service Manual page 1138

MECHANICAL
34) Separate the cylinder block LH and RH.
NOTE:
When separating the cylinder block, do not allow
the connecting rod to fall or damage the cylinder
block.
(5)
(6)
(1) Cylinder block
(2) Rear oil seal
(3) Crankshaft
35) Remove the rear oil seal.
36) Remove the crankshaft together with connect-
ing rod.
37) Remove the crankshaft bearings from cylinder
block using a hammer handle.
NOTE:
• Press the crankshaft bearing at the end opposite
to locking lip to remove.
• Be careful not to confuse the crankshaft bearing
combination.
38) Remove each piston from the cylinder block us-
ing a wooden bar or hammer handle.
NOTE:
Be careful not to confuse the original combination
of piston and cylinder.
Cylinder Block
(7)
(1)
(4)
(3)
(4) Crankshaft bearing
(5) Piston
ME(H4DOTC)-80
(2)
(4)
(1)
(5)
(6) Seal washer
(7) Washer
ME-02890