Subaru 2009 IMPREZA Service Manual page 1255

ENGINE (DIAGNOSTICS)
9. Subaru Select Monitor
A: OPERATION
1. HOW TO USE THE SUBARU SELECT
MONITOR
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4DOTC)(diag)-7,
General Description.>
2) Prepare the personal computer which has been
installed the Subaru Select Monitor.
3) Connect the USB cable between SDI (Subaru
Diagnosis Interface) and USB port on the personal
computer (dedicated port for the Subaru Select
Monitor).
NOTE:
The dedicated port for the Subaru Select Monitor
means the USB port which was used to install the
Subaru Select Monitor.
4) Connect the diagnosis cable to the SDI.
5) Connect the SDI to data link connector located in
the lower portion of the instrument panel (on the
driver's side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor and general scan tool.
6) Start up the personal computer.
7) Turn the ignition switch to ON (engine OFF), and
run the "PC application for Subaru Select Monitor".
8) Call up DTC and data, then record them.
NOTE:
For detailed operation procedure, refer to the "PC
application help for Subaru Select Monitor".
Subaru Select Monitor
PREPARATION TOOL,
EN-05692
EN-06148
EN(H4DOTC)(diag)-34