Clutch Fluid Replacement/Air Bleeding; Clutch Fluid Draining; Clutch Fluid Filling - Honda 1985 CBX750F Workshop Manual

HONDA
CBX750F
CLUTCH
CLUTCH FLUID REPLACEMENT/
AIR BLEEDING
Check the fluid level with the fluid reservoir parallel
to the ground.
CAUTION
• Do not allow foreign material to enter the
clutch system when filling the reservoir.
• Avoid spilling fluid on painted surfaces.
Place a rag over the fuel tank whenever
the system is serviced.
CLUTCH FLUID DRAINING
Remove the reservoir cap and diaphragm .
Connect a bleed hose to the bleed valve.
Loosen the slave cylinder bleed valve and pump the
clutch lever. Stop operating the lever when no fluid
-flows out of the bleed valve.
CLUTCH FLUID FILLING
NOTE:
Do not mix d ifferent types of fluid since they
are not compatible.
Close the bleed valve and f ill the reservoir.
Pump up the system pressure with the lever until
there are no air bubbles in the fluid flowing out of
the reservoir small hole and lever resistance is felt.
Then bleed the system (below).
AIR BLEEDING
NOTE:
• Check the fluid level often while bleeding
the clutch to prevent air from being pump ­
ed into the system.
• Use only DOT 4 brake fluid from a sealed
container.
• Do not mix brake fluid types and never
reuse the fluid which has been pumped out
during bleeding, or the efficiency of the
clutch system will be impaired.
( 1) LOWER LE VEL
(1) B LEED V L A V E
8-3