Task 1: Configure Ip And Ethernet Interfaces; Configuring The Management Pc - Motorola PTP 600 series User Manual

Task 1: Configure IP and Ethernet interfaces

Task 1: Configure IP and Ethernet interfaces
This task consists of the following procedures:
•

Configuring the management PC

•
Connecting to the PC and powering up
•
Logging into the web interface
•
Updating the IP and Ethernet configuration
•
Reconnecting to the management PC
Configuring the management PC
To configure the local management PC to communicate with the PTP 600, proceed as
follows:
Procedure 6-1 Configure the IP interface on the PC
1
2
3
4
5
6-2
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Select Properties for the Ethernet port.
Select the Internet Protocol (TCP/IP) item as shown in
Click on Properties.
If the default IP addresses of the units are 169.254.1.2 (Master) and
169.254.1.1 (Slave), enter an IP address that is valid for the
169.254.X.X network, avoiding:
169.254.0.0 and 169.254.1.1 and 169.254.1.2
If the default IP addresses of the units are 10.10.10.11 (Master) and
10.10.10.10 (Slave), enter an IP address that is valid for the 10.10.X.X
network, avoiding:
10.10.0.0 and 10.10.10.10 and 10.10.10.11
For example, the interface in
address of 169.254.1.3.
Enter a subnet mask of 255.255.0.0.
Leave the default gateway blank.
Chapter 6 Configuration and alignment
on page 6-2
on page 6-4
on page 6-4
on page 6-6
on page 6-11
Figure 6-2 is configured with an IP
Figure 6-1.
phn-0896_012v000
Jul 2010