Motorola PTP 600 series User Manual page 369

User Guide: PTP 600 Series
Attribute
Management
Mode
Data Port Auto
Negotiation
Data Port Forced
Configuration
phn-0896_012v000
Jul 2010
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Only displayed when Use VLAN for Management Interfaces is
enabled (Figure 6-4).
'In-Band' means that the web interface can be reached from
the data port at both the local and remote ODUs (assuming
that the wireless link is established).
'In-Band Local' means that the web interface can be reached
from the data port at the local ODU only. If this is selected,
ensure that the same VLAN Management VID is configured at
both ends of the link.
'Enabled' means that configuration is automatically
negotiated. This is the default setting.
'Disabled' means that configuration is forced.
Use the same setting for both ends of the link.
When Data Port Auto Negotiation is Disabled, the format of
the LAN configuration page changes
The configuration should only be forced if problems are
experienced with auto-negotiation.
NOTE
Instead of forcing configuration, the IEEE802.3
specification recommends enabling Auto Negotiation
with only the specific ability or abilities advertised.
Only displayed when Data Port Auto Negotiation is disabled
(Figure 6-5).
This forces the speed and duplex setting of the Ethernet
interface. Over the air throughput will be capped to the rate
of the Ethernet interface at the receiving end of the link.
Use the same setting for both ends of the link.
CAUTION
The same configuration must be forced on connected
network equipment, otherwise a duplex mismatch will
occur and data throughput will be greatly reduced.
Task 1: Configure IP and Ethernet interfaces
Meaning
(Figure 6-5).
6-9