Chapter 5 Installation
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter provides instructions for installing a PTP 600 link.
IN NO EVENT SHALL MOTOROLA, INC. BE LIABLE FOR ANY INJURY TO ANY
PERSONS OR ANY DAMAGE CAUSED DURING THE INSTALLATION OF THE
MOTOROLA PTP 600 SERIES PRODUCT.
CAUTION
A standard PTP 600 Series installation process consists of the following tasks:
•
Preparing for standard installations
•
Preparing and connecting cables
•
Installing the ODU and top LPU
•
Installing the drop cable and ground cables
•
Installing the PIDU Plus
The following tasks may also be required for installation options:
•
Installing a connectorized ODU and antenna
•
Installing an UltraSync GPS receiver
•
Installing a PTP-SYNC unit
•
Installing a GPS receiver for PTP-SYNC
•
Installing an E1 or T1 interface
phn-0896_012v000
Jul 2010
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Motorola recommends that only qualified personnel undertake the
installation of a PTP 600 Series solution.
Motorola recommends that the practices and procedures detailed in manual
R56 STANDARDS AND GUIDELINES FOR COMMUNICATION SITES
(68P81089E50)
should be applied to all new site build activities. This manual
is provided on the PTP 600 CD-ROM.
on page
on page
5-2
on page
5-3
on page
5-12
on page
5-24
on page
on page
5-34
on page
5-37
on page
5-42
on page
5-49
Chapter 5
5-18
5-28
.
.
.
.
5-1