Task 4: Configure security
Step 6: HTTP and Telnet settings
The PTP 600 can be remotely managed in four ways: HTTPS, HTTP, Telnet or SNMP.
NOTE
If the unit is required to operate in FIPS 140-2 secure mode, HTTP, Telnet
and SNMP Control must all be disabled.
To configure HTTP and Telnet via the Security Wizard, proceed as follows:
Procedure 6-19 Configure HTTP and Telnet
1
The Step 6: HTTP and Telnet Settings page is displayed
2
Review and update the HTTP and Telnet attributes
3
Select Next.
Figure 6-24 Step 6: HTTP and Telnet Settings page
6-32
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Chapter 6 Configuration and alignment
(Figure
6-24).
(Table
6-3).
phn-0896_012v000
Jul 2010