Managing spectrum
Managing spectrum
This section describes how to configure the spectrum management feature of the
PTP 600 and how to interpret spectrum management graphical plots.
This section contains the following procedures:
•
Configuring spectrum usage at the master
•
Viewing spectrum usage at the slave
•
Interpreting the spectrum management plots
•
Viewing the active channel history
•
Viewing historic spectrum management metrics
Configuring spectrum usage at the master
All spectrum management configuration changes are applied at the master ODU only.
These changes are then sent from the master to the slave, so that both master and
slave keep identical copies of spectrum management configuration. It is therefore
possible to swap master and slave roles on an active PTP 600 link without modifying
Spectrum Management configuration.
NOTE
Before attempting to improve the performance of the spectrum management
algorithm by changing the default configuration, consulting the Motorola
Point-to-Point distributor or one of the system field support engineers.
The default channelization can be modified by varying the lower center frequency
attribute in the installation wizard, as described in
page 6-54.
To configure spectrum usage at the master, proceed as follows:
Procedure 7-1 Configure spectrum usage at the master
1
Log into the master ODU for the link.
2
Select menu option System, Spectrum Management. The Spectrum
Management page is displayed
3
Review and update the configuration attributes
4
Select Submit configuration changes.
7-22
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
on page
7-22
on page
7-25
on page
7-27
on page
7-36
on page
Step 2: Wireless configuration
(Figure
7-8).
(Table
Chapter 7 Operation
7-37
on
7-6).
phn-0896_012v000
Jul 2010