Preparing For Standard Installations - Motorola PTP 600 series User Manual

Preparing for standard installations

Preparing for standard installations
NOTE
It is common practise to pre-configure the ODUs during staging before site
installation. Refer to
information.
Before proceeding with the installation, perform the following checks:
•
Check that a link plan is available and that it is based on the principles described
in Chapter 2 Planning
•
Check that the correct components are available. For a typical inventory, refer to
Inventory for standard installations
•
Check the contents of all packages against the parts lists shown in their packing
lists.
•
Ensure that qualified installers are available to undertake the work.
•
Ensure that all safety precautions can be observed.
The following specific tools are required to install a PTP 600 Series, in addition to
general tools:
•
13mm wrench and 22 mm wrench for use with the glands.
•
RJ45 crimp tool (it must be the correct tool for the type of RJ45 being used).
•
Personal Computer (PC) with 10, 100 or 1000 BaseT Ethernet.
•
Either Internet Explorer 7, Internet Explorer 8, Firefox 3 or Firefox 3.5.
•
Ethernet patch cables.
5-2
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Chapter 6 Configuration and alignment
considerations.
on page 4-2.
Chapter 5 Installation
for more
phn-0896_012v000
Jul 2010