Grounding The Drop Cable; Figure 5-2 Drop Cable With Rj45 And Gland - Motorola PTP 600 series User Manual

User Guide: PTP 600 Series
CAUTION
Figure 5-2

Figure 5-2 Drop cable with RJ45 and gland

Grounding the drop cable

Perform this task to connect the screen of the drop cable to the metal of the
supporting structure using a cable grounding kit.
The cable grounding kit for 1/4" and 3/8" cable
components:
•
1 x grounding cable with grounding 2 hole lug fitted (M10)
•
1 x self Amalgamating tape
•
1 x PVC tape
•
3 x tie wraps
•
2 x bolt, washer and nut
CAUTION
To ground the drop cable to a metal structure, proceed as follows:
phn-0896_012v000
Jul 2010
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
The cable inner sheath must be located correctly under the connector
housing tang. If this is not done correctly, there is no strain relief on the
cable terminations.
shows the end of a drop cable fitted with an RJ45 plug and a gland.
Ground cables must be installed without drip loops and pointing down
towards the ground, otherwise they may not be effective.
Preparing and connecting cables
(Figure 1-14) contains the following
5-5