User Guide: PTP 600 Series
Installing a PTP-SYNC unit
If the chosen TDD synchronization method requires PTP-SYNC (see
synchronization configurations supported
install a PTP-SYNC unit.
This task consists of the following procedures:
•
Preparing for PTP-SYNC installation
•
Mounting the PTP-SYNC unit
•
Connecting up the PTP-SYNC unit
•
Powering up the PTP-SYNC installation
CAUTION
CAUTION
CAUTION
Preparing for PTP-SYNC installation
Check that the correct components are available. For a typical inventory, refer to
Inventory for PTP-SYNC installations
phn-0896_012v000
Jul 2010
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
The PTP-SYNC unit should not be installed in a domestic (home)
environment as it is a Class A product. In a domestic environment, it may
cause radio frequency (RF) interference in other appliances.
The PTP-SYNC unit must be installed indoors in a non-condensing
environment, otherwise it will be prone to water damage.
To protect the PTP-SYNC from damage, disconnect the power supply from
the PIDU Plus before connecting up the PTP-SYNC.
on page 2-27), then perform this task to
on page
5-37
on page
5-38
on page
5-39
on page
5-41
on page 4-8.
Installing a PTP-SYNC unit
TDD
5-37