Using recovery mode
Erasing configuration
To erase the entire configuration of the unit from the Recovery Options page
8-8) , proceed as follows:
Procedure 8-19 Reset IP and Ethernet configuration when in recovery mode
1
Select Erase Configuration. The pop up box is displayed.
2
Select OK. The confirmation page is displayed.
3
Select Reboot. When the 'Are you sure?' pop up box is displayed, select OK.
4
The unit will now reboot. The unit should now start up in normal mode but
with all configuration erased. If the unit fails to start up, refer to
end hardware
8-26
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
on page 8-2.
Chapter 8 Troubleshooting
(Figure
Test link
phn-0896_012v000
Jul 2010