User Guide: PTP 600 Series
Table 8-3 Recovery Options attributes
Software Version
Recovery Reason
MAC Address
Table 8-4 Recovery Options buttons
Upgrade Software Image
Reset IP & Ethernet
Configuration back to factory
defaults
Erase Configuration
Zeroise Critical Security
Parameters
Reboot
phn-0896_012v000
Jul 2010
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Attribute
Button
Meaning
The software version of the recovery operating
system permanently installed during manufacture.
The reason the unit is operating in Recovery mode,
for example 'Recovery button active' or 'Invalid or
corrupt image'.
The MAC address shown here is the MAC address
of the unit programmed during manufacture.
Purpose
Use this option to restore a working software
version when software corruption is suspected, or
when an incorrect software image has been loaded.
Refer to
Upgrading software image
Use this option to restore the IP and Ethernet
attributes to their defaults. Refer to
Ethernet configuration
Use this option to erase the entire configuration of
the unit. This will also erase factory settings such
as target MAC address, range setting and license
key. Refer to
Erasing configuration
Use this option to reset encryption keys and the
system administrator password. Refer to
critical security parameters
Use this option to reboot the unit. Refer to
Rebooting the unit
on page 8-27.
Using recovery mode
on page 8-24.
Resetting IP &
on page 8-25.
on page 8-26.
Zeroizing
on page 7-40.
8-23