Table 6-10 Step 2: Wireless Configuration Attributes - Motorola PTP 600 series User Manual

Task 7: Configure wireless interface
The contents of the Wireless Configuration page vary depending upon the frequency
variant as follows:
•
PTP 25600: Frequency Band field is also displayed.
•
Channel Bandwidth options vary depending upon frequency variant and region.
For more information, see
•
PTP 49600: Lower Center Frequency is not displayed.
Page contents also vary depending upon the options selected as follows:
•
If Spectrum Management Control is set to 'Fixed Frequency', the Lower Center
Frequency field is replaced by Fixed Tx Frequency and Fixed Rx Frequency.
•
If Platform Variant is set to 'Connectorized', Antenna Gain and Cable Loss are
also displayed.

Table 6-10 Step 2: Wireless Configuration attributes

Attribute
Access Method
Link Name
Group ID
6-56
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Table 1-1.
'Link Access' means that the link is established between a
pre-paired Master and Slave.
'Link Name Access' means that a link can only be established
between units that have identical Link Name attributes.
'Group Access' means that a link can only be established
between units that have identical Group ID attributes.
Only displayed when Access Method is set to 'Link Name
Access'. A link can only be established between units that
have identical Link Names.
Link Name may consist of letters (A-Z and a-z), numbers (0-
9), spaces, and the following special characters:
(),-.,:<=>[]_{}
Only displayed when Access Method is set to 'Group Access'.
A link can only be established between units that have
identical Group IDs.
Chapter 6 Configuration and alignment
Meaning
phn-0896_012v000
Jul 2010