Task 6: Set Passwords; Creating Or Updating Identity-Based Users - Motorola PTP 600 series User Manual

Task 6: Set passwords

Task 6: Set passwords
This task consists of the following procedures:
•

Creating or updating identity-based users

•
Changing own user password
•
Protecting access to the summary and status pages
Creating or updating identity-based users
Perform this task to allow multiple users (from one to ten) to access the ODU with
different levels of access. There are three defined levels of access: Security Officer,
System Administrator and Read Only.
NOTE
If the unit is required to operate in FIPS 140-2 secure mode, at least three
identity-based used accounts must be created, and the Secuirty Officer
password must be compliant with network security policy.
If identity-based user accounts are already enabled, this task may only be performed
by a user with role set to Security Officer.
To create or update identity-based user accounts, proceed as follows:
Procedure 6-22 Configure user accounts
1
Select menu option Management, Web, Local User Accounts. The User
Accounts page is displayed
2
Set the Identity Based User Accounts attribute to 'Enabled' (if it is not
already set). The identity-based user account attributes are enabled for
update
3 Create or update up to 10 user accounts
4 If any accounts have been created or updated, select Submit User Account
Updates.
6-42
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
on page
(Figure
(Figure 6-27).
Chapter 6 Configuration and alignment
on page 6-42
6-44
on page
6-26).
(Table 6-6).
phn-0896_012v000
6-45
Jul 2010