Table 5-1 Trimble Connector To Rj45 Pin Mappings - Motorola PTP 600 series User Manual

User Guide: PTP 600 Series
Connecting the drop cable to the GPS receiver
If the chosen GPS receiver is Trimble Acutime™ Gold, then follow this procedure.
The drop cable connecting the Trimble GPS receiver to the LPU must be of the
supported cable type. The drop cable must have a Trimble 12-pin connector at the GPS
end (supplied in the Trimble kit), and an RJ45 connector and standard gland at the
LPU end.
CAUTION
Table 5-1
map to the RJ45 connector pins (at the LPU end).
the pins in each type of connector.

Table 5-1 Trimble connector to RJ45 pin mappings

Trimble
12-pin conn
1
2
3
4
5
6
7
8
9
10
11
12
phn-0896_012v000
Jul 2010
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
The drop cable has solid copper conductors. There is a limited number of
times each conductor can be bent before it fatigues and fails.
shows how the Trimble connector pins (at the GPS end of the drop cable)
Function
DC Pwr
(12V)
RxB-
RxB+
TxB-
TxB+
RxA-
RxA+
TxA-
DC Ground
TxA+
Tx1PPS+
Tx1PPS-
Installing a GPS receiver for PTP-SYNC
Figure 5-21
RJ45 wire colour
Conventional Supported
drop cable
Orange/White Light Orange
Brown/White Light Brown
Brown Brown
Blue Blue
Blue/White Light Blue
N.C N.C
N.C N.C
N.C N.C
Orange Orange
N.C N.C
Green/White Light Green
Green Green
shows the positions of
PTP-SYNC
(J10)
RJ45 pin
1
7
8
4
5
---
---
---
2
---
3
6
5-43