Integrator Assembly - Christie CP2210 Service Manual

Section 5: Parts and Module Replacement

5.6.10 Integrator Assembly

UV HAZARD! Always wear protective safety clothing and a face shield when performing
service with the safety shield removed and a lamp installed.
NOTICE: The integrator must be installed flush to the output aperture. Failure to do this may cause damage
to the optical system. If these symptoms are observed immediately contact Christie Technical Support staff.
Always wear gloves when handling the integrator assembly.
The integrator assembly is mounted in the light tube of the IOS. It runs through a firewall cutout, which
separates the lamp housing from the light engine.
(Estimated Replacement Time: 35 minutes; includes 5 minutes for alignment)
1. Remove the top lid. Refer to
2. Remove safety shield. Refer to
3. Use a #1 Phillips
4. Remove the side service skin door. Refer to
5. Disconnect the thermal harness from the light sensor (Figure 5-65).
5-46
5.5.5 Top Lid, on page
5.5.12 Safety Shield, on page
to remove integrator temperature sensor (Figure 5-64).
™
Figure 5-64 Integrator Temperature Sensor
Figure 5-65 Disconnect Thermal Harness
5-7.
5-10.
5.5.11 Exhaust Panel Skin, on page 5-10.
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)