Christie CP2210 Service Manual page 122

Section 7: Serial API
Output Reference Delay (phase) (TDP)
Set output reference delay phase for 3D control. This is an additional control for output timing relative to input
timing. The data range is -180 to 180.
SUBCODE DESCRIPTION OF USE
Cxxx
Replace xxx with the channel number. Valid range is 101 - 164.
NONE
Select output reference delay phase for the current channel
EXAMPLES:
(TDP+C101 1) Set output reference delay phase to 1 on channel 101
(TDP+C101?) Get output reference delay phase on channel 101
3D L/R Display Reference (TDR)
Set the L/R display reference for 3D control.
SUBCODE DESCRIPTION OF USE
Cxxx
Replace xxx with the channel number. Valid range is 101 - 164.
NONE
Select L/R display reference for the current channel
EXAMPLES:
(TDR+C101 1) Set L/R display reference to 1 on channel 101
(TDR+C101?) Get L/R display reference on channel 101
Output Reference Delay (time) (TDT)
Set output reference delay time for 3D control. This command controls how much delay between the input and out-
put reference timing.
SUBCODE DESCRIPTION OF USE
Cxxx
Replace xxx with the channel number. Valid range is 101 - 164.
NONE
Select reference delay for the current channel
EXAMPLES:
(TDT+C101 1) Set output reference delay time to 1 on channel 101
(TDT+C101?) Get output reference delay time on channel 101
L/R Display Sequence (TFD)
Set L/R Display Sequence for 3D control. This selects which signal is considered first in the source signal, the left
or the right.
SUBCODE DESCRIPTION OF USE
Cxxx
Replace xxx with the channel number. Valid range is 101 - 164.
NONE
Select L/R display sequence for the current channel
EXAMPLES:
(TFD?L) List all entries on Input Frame Dominance control
(TFD+C101 1) Set Input Frame Dominance to 1 on channel 101
(TFD+C101?) Get Input Frame Dominance on channel 101
7-22 CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)