Touch Panel Controller (Tpc) - Christie CP2210 Service Manual

Section 5: Parts and Module Replacement

5.5.4 Touch Panel Controller (TPC)

The TPC is located at the back of the projector. It is attached to a ball-joint mount which allows it to be viewed
at any angle. The TPC can also be removed and be held by the operator. The TPC provides a user-friendly
interface that runs off a fully integrated Windows XPe-based operating system.
(Estimated Replacement Time: 4 minutes)
1. Remove the TPC. (Figure 5-3)
a. Disconnect the TPC cable from the projector's back cover.
b. Loosen the TPC mounting arm so it can be removed from the ball joint on the projector's back cover.
(Figure 5-3)
c. When replacing, repeat the instructions in reverse.
d. If using a TPC-660E, check the main switch on the back of the TPC before reinstalling it. Ensure that
it is connected properly. (Figure 5-4)
5-6
Figure 5-3 Remove TPC
Figure 5-4 Main Switch on TPC-660E
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)