Christie CP2210 Service Manual page 71

5. Disconnect the two quick disconnect hoses to the light engine (Figure 5-41).
6. Use a 4mm hex key to remove the two screws from the bracket securing the reservoir and pump (Figure 5-
41).
7. Loosen the two screws securing the side skin in order to pull the skin aside and slide the cooling assembly
out (Figure 5-41).
8. Reverse the above steps to install. NOTE: When reinstalling, ensure there are no kinks in the hoses.
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)
Figure 5-41 Quick Disconnects
Section 5: Parts and Module Replacement
5-29