Section 5: Parts and Module Replacement
5.5.28 Light Dump
The light dump is mounted to the front of the light engine compartment and is held in place by a single captive
screw.
(Estimated Replacement Time: 20 minutes)
1. Remove the top lid. Refer to
2. Remove the high security lid. Refer to
3. Using a 3mm hex key, remove the two screws securing the light engine cover (Figure 5-42).
4. Using a #1 Phillips
5. Reverse the above steps to install. Ensure that the light dump is aligned with the alignment pin when
installing.
5-30
5.5.5 Top Lid, on page
5.5.6 High Security Lid, on page
Figure 5-42 Remove Light Engine Cover
, loosen the captive screw securing the light dump (Figure 5-43).
™
Figure 5-43 Remove Light Dump
5-7.
5-7.
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)