Integrator Assembly - Christie CP2420-Xe Service Manual

3. Loosen the other screw from each of the three tabs.
4. Holding the mirror in place, swing the tabs out to the side.
5. Carefully lower the mirror and remove it.
6. To re-install, follow these steps in reverse order.
7. Adjust the fold mirror as needed (on page 20).

Integrator assembly

The integrator assembly is positioned between the illumination optic system (IOS) and the lamp
compartment.
Wear the clean handling gloves provided in the service kit whenever handling the integrator.
1. Remove the front top cover (on page 50).
2. Remove the two screws securing the retaining clip to the rear of the integrator.
CP2420-Xe and CP4420-Xe Service Guide
020-103566-02 Rev. 1 (07-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Optics
103